I have framed the zig-zag with my fingers and you can see the contrasting yarn barely shows. This method is very secure, but it is a little more bulky and noticeable than the other two methods. Like the zig-zag, you weave your yarn diagonally under the "bumps". However, instead of going under every bump, you alternate. Then, you weave back through the skipped bumps. The tension of the fabrics secures the yarn tail very tightly. On the right side the weaving is somewhat visible, but this would not be as much of an issue when you are using the same yarn you knit with.Step 1. Thread about 18″/45cm of yarn onto a tapestry needle. Identify the first stitch you wish to duplicate. It should be at the bottom of your design. Insert needle from back to front at the point of the V of the stitch to be duplicated. Pull needle through, leaving 3-4″ tail of yarn, to be woven in later. Insert needle from right to left behind the shoulders of the stitch above the one you are duplicating. You will see that the right-hand leg of the stitch is now duplicated. Insert needle from front to back through the point of the V from Step 3. You will see that the left-hand leg of the stitch is now duplicated. Move on to the next stitch to be duplicated, and repeat from Step 3. Work bottom to top, alternating right to left and left to right as rows are completed. Use the tip of the tapestry needle to adjust the tension as necessary. When you are finished with your motif, cut yarn with 4″/10cm remaining and weave in ends on the wrong side. Can you believe its time for another Knit-along Man, I feel like weve been knitting-along with a fervor, lately. Yarn used in this tutorial is Lazy Bee Yarn Clover DK. Pattern used in this tutorial is the Lonely Hearts Club Hat 2022. Read about our annual Lonely Hearts Club Hat KAL in our blog.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |